qleeno QS101 Operating Instructions Manual page 5

PREPARATION
WARNING: Always turn Qleeno completely off and disconnect from power source when making
!
adjustments, changing brushes, performing any type of cleaning, maintenance, or repair work.
CAUTION: Never use Qleeno without an extension cord, brush or pad holder with pad. Use only accesso-
!
ries and equipment supplied or recommended by the manufacturer.
Before Each Use
1. Inspect Qleeno to make sure no damage has occurred during transport, storage or previous use.
2. Inspect squeegee ring and change if edges or suction hoses show excessive wear.
3. Inspect brush or scouring pad - replace if necessary.
4. Ensure that correct brush/scouring pad is securely mounted to machine.
5. Adjust casters to proper height (ref. page 6).
6. Fill water tank with fresh water and chemical (if desired).
NOTICE: Follow chemical manufacturer's instructions when using cleaning agent. Use only non-foaming clean-
ing agents.
NOTICE: Qleeno is not intended to be used as a buffer. Do not fill water tank with wax.
NOTICE: After removing water tank, always carry with drain end down - water tank can spill if carried incorrectly.
When replacing, set rear of tank on metal posts in frame side and insert tank ports in matching frame
orifices.
NOTICE: Always empty dirty water before each use.
Fresh Water Fill
Dirty Water Drain
Carry water tank drain end down -
water can leak through ports in front.
5
Place Water tank on metal posts at rear
frame.