Installing The Battery - KTM 690 ENDURO EU Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
Installing the battery
x
9.51
–
Disconnect the negative (minus) cable of the battery.
–
Pull off connector
–
Remove screws
–
Pull retaining bracket
–
Take off the positive terminal cover
–
Disconnect the positive (plus) cable of the battery.
–
Press the wiring harness to one side and pull the battery out of the battery rack.
Info
100277-10
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components can safety equipment can be damaged. The
vehicle is then no longer safe to ride.
–
Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
–
Attach the positive cable and mount positive terminal cover
–
Position retaining bracket
–
Mount and tighten screws
Specification
100277-11
Remaining screws, chassis
–
Plug in connector
–
Attach the minus cable .
–
Mount the seat. (
in an upward direction.

.

of the battery forward and remove it.

.

.

.

.

P. 103)
.

M6 10 Nm (7.4 lbf ft)
104