Caring For Your Projector - Eumig MARK 607 D Manual

Caring for your projector
All moving parts of the Mark 610 0 are permanently lubricated and require no
attention.
The film guides and film channel should be cleaned from time to time. With a soft
cloth ora camel's hair brush, carefully remove dust and emulsion particles. To gain
access to the film channel, pressure pad and film guides, take off the lamp housing
and swing up the lens gate. But first move the function sWitch to the top"
0 "
(off) position and pull out the line (mains) plug.
o
Use a coin to turn the screw, then take off the lamp
housing.
e
Push the lens-gate latch toward the left. The lens
gate wi ll swing up.
e
To olean the lens (with a soft, lint-free cloth or a
camel's hair brush), pullout the focusing knob a
little.
e
Uft the lens out of the lens gate.
o
Before replacing, check that the engageme nt
groove of the lens faces you (see illustration). Now
pull out the focusing knob aga in , push the lens
into the carrier tube and let it engage.
Now swing the lens gate back in place and replace the lamp housing .
Proper film care is important. Clean your films occasionally with a commercial film
cleaner. Store them in dust-tight cans in a cool, not-too-dry place .
9