Eumig MARK 607 D Manual page 5

Before you plug it in ...
. . . make sure that your house current (Ae) , line (mains) frequency (50 or 60 Hz, or
cycles) and voltage are the same as those shown on the ma nufacturer's rating plate
on the projecto r.
To change the projector operating voltage: (Caution:
First disconnect the power cord [mains lead) .)
o
Remove the back cover after loosening the two
mounting screws .
6
Pull out th e I'ed co n-
nector an d pl ug it
on to the prope r pin .
11,4V
Replace the back
12
v
S electing the film format
Super 8 or Single 8 film:
cover .
To
change the line
(mains) frequency: If your
projector is- a unive rsal
model wi th provisio n for
fre qu ency adju stme nt, fol -
low t he directi ons give n
on t he in side of .the back
co ve r.
S li de the film-format selector lever
0
down . During projection , the blue indicator
lamp will light up.
Leave the adapter sleeve
6
on the reel
spindle.
Regular 8 film:
Slide the f ilm-format selector lever
0
up.
During projection, the amber indicator
lamp will li.g.ht up.
Remove the spindle adapter
6
and store
it. in the well
e
provided for the purpose .
2,4V
o
Regular 8 reels are pushed directly onto the ree l spind le. SupeF 8 reels seat bette r if
the spind le adapter i' s first sHpped onto the spind le. Howeve,r, Supe r 8 reels can also
be used without an adapter.
Getting ready to show a movie
To take full advantage of the fast rewind through the film chan nel , splice a 20- in ch
length of leader to the head and tail ends of your film (unless it was returned to you
f rom the processor with a leader attached). For trouble-free ope ration of t he
automatic threading mechanism , trim the leading edge of the leader squ arely with
the built-in film cutter and curl the first few inches c lockwise . A v oid creasing the fi lm . .
Insert about
11/4
inch of film into the slot on the
side , as shown at
0,
and press the key
6 .
Avoid
cutting through perforations by inserting Regular 8
film so that a perforati·on is lined up with the edge
of the slot, and Super 8 or Single 8 film so that the
edge of the slot is midway between two perforations.
5