Eumig MARK 607 D Manual page 6

Be sure to move the function switch to the"
0 "
(off) position befo.re plugging
the projector in.
o
Plug the power cord (mains lead) into an
outlet.
S
Swing the reel arm up to the click stop.
f)
Place the full reel on the reel arm (with the
perforations facing you) and flip over the
reel guard.
Films wound the wrong way (not as shown
here) must be rewound twice for projection.
o
Push the universal film reel supplied with the
projector onto the takeup-reel spindle all the
way to the stop.
o
Move the function switch to the auto thread-
ing pos ition ( ) (The projection lamp is now
being preheated . Pi lot goes on with the
Mark 610 D.)
o
Feed the film end into the threading slot until
it is caught by the threading mechanism. The
rest of the threading operation is fully
automatic.
0 ,
Move the function switch to the forward with
lamp position
0
o
For reverse projection, move the function
switch past the"
0"
(off) position to the
reve·rse with lamp position
0
o
Turn the zoom ring to HII the screen.
~
Bring the picture into focus by turning the
focusing knob.
tD
If a frame line shows on the screen, move
the framing lever until it disappears.
Ii) Adjust the tilt control to rais'e or lower the
projected p icture.
Caution: Take care to operate the projector so that air is able to circulate freely
through the ventilating slots in the case and the back cover ..
6