Before Connecting Your Projector To The Mains - Eumig Automatic P8 Manual

Fig. 4
Fig. 3
Before connecting your projector to the mains
please refer to your electricity meter to check up on your
mains supply. The EUMIG P B AUTOMATIC will operate
only on 10—220 volt (T10—240 volt) A.C. (50—&0 eydles). The
voltage selector A (Fig. 4) above the mains socket is nor
mally set to 220 volts. If you da not have 220 volt current, vou
must adjust the voltage selector by turning if until the correct
voltage is opposite the white dot. Before you raset the vol-
tage selector, vou must disconnect the mains lead. Now
swing out he two spool arms (Fig.5) — the drive belts al-
ways remain in position.
You tan now connect the P B AUTOMATIC to the mains by
inserting the female plug of the mains lead supplied inte
socket B (Fig.4|. Please notice the connection for room
lighting (C, Fig. 4). We suggest that you tonmmert a table
lamp or small standard lamp to sorket €. The lamp gees out
automatically when the projector is switched on and comes
on again when the projector is switdhed off.