Advertisement
This light equipment can be delivered by any conveyance after packed, but
should avoid rain, snow and damage the equipment.
This light should be kept in the temperature of -20—40t2. The harmful air or
flammable and easy-exploded chemical objects should be keep away from
the warehouse, and the violent vibration and strong magnetic field
interferences should also be avoided.
Power cable should be chose according to the power of the light If the lamp
use the HMI1200W bulb, then it must use the
2
three core cable 2mm
; if die lamp use die HMI2500W bulb, then it must use
the three core cable with the section area 4mm .
Don't turn ON/OFF the power at random. Turn on the light again must after 20
minutes later in order to cool down the bulb completely.
Don't look at the beam directly or it will hurt your eyes.
Confirm the fan working perfectly before turning on the light. Use the light
under the condition of cooling system does not work.
This light cannot using for too long time once, otherwise the lamp damage
easily, the longest time is no more than 6 hours.
The proper working voltage is 220V, 50 Hz, and the voltage should not lower
than 200V or higher than 240V, otherwise the bulb will damage or work falsely
and shorten the normal service life of the light.
In the process of operating, if discover some light breakdown, please pause to
use this light, avoid to use the light long time under non normal condition.
In the process of operating, if the control signal in mess or out of control,
checking if the control signal of the light is wrong or not or short-cut.
Page 6
www.flash-butrym.pl
Advertisement
