Advertisement
DMX512 Connection
Controller output 1DMX512 standard signal, connects via output and
input...The three pin XLR 1 is grounding, 2 is negative and 3 is positive, or
change 2 and 3 (The controller generally don't need to change these two
pins). The length of signal cable should be within 100 meters, to avoid die
interference by other electric appliances because of too long signal cable. Big
electric cable or signal-amplifier is suggested to use for the long distance.
Please use the step output cable, matching wife the socket, output connector
connect wife the input connector of fee next equipment.
Don't dismantle output cable into two output cable, and it cannot over-loaded.
One line maxima can connect wife 32 machines. When use digital control
input signal, all equipment must have one digital ADD number, for fee
purpose of relevant lamp arid relevant control signals working, and this ADD
No. is a band Number. Light machine starting is obey to fee control signal
which transmitted out by controller.
Each follow spot light is to obey a group of 4 band signal, they all start with
the one given digital ADD signal that is given in advance, and fee allotment of
these addresses is set by the light DIP address code. Detail is as the following
chart
Address code:
1
2
1
2
Example 1: If the controller is 10 channels, so the first light ADD is 0, the
relevant ADD is 0, then turn on address 10 convert to DMX512 signal, so the
first light should turn on ADD 10; the formula of the second light is 0 add the
number of channels
10=2+8, then the second lamp should turn on 2 and 4 addresses of;...the sixth
light formula is 0+10+10+10+ 10+10=50(5(h
should pull out 2,5 and 6. And so on.
www.flash-butrym.pl
3
4
5
4
8
16
6
7
8
32
64
128
B
2+16+32), so the sixth lamp
9
10
256
512
Page 4
Advertisement
