Table of Contents
Advertisement
(b) Adjusting the Sealing Time
Depending on the size and quality of the strap, different welding times are required.
Turning
the knob
counterclockwise decreases the welding time.
(4) Feeding the Strap Around the Package
The strapping is fed around the package as illustrated.
Warning! The plastic strap which will be welded
must be free from oil, grease and other dirt.
Dirty plastic straps can't be welded correct!
(5) Inserting the Strap
Pull up the handle lever firmly with your right hand.
Insert the two straps well aligned on each other into
the strap guide using your left hand.
Release the handle lever.
(6) Tensioning and Sealing the Straps
-Auto
Press down the rocker switch until the desired strap
tension is
reached.
Release the rocker switch when it's finished.
-Semi
Press down the rocker switch and then release it, and
press down again and again
reached.
-Sealing the Straps
Press the black switch to sealing the straps.
The plastic strap is welded and cut off from the strap coil at the same time.
During welding, the LED lights green.
After expiration of the adjusted welding time, the cooling down time begins (LED lights
yellow).
When the LED lights green again, the sealing procedure is finished.
clockwise increases
The
tool will do sealing by
till
the desired tension is
- 7 -
the welding time, while turning it
itself.
Hide quick links:
Advertisement
Table of Contents
