Table of Contents
Advertisement
To set up an echo station, follow these steps:
1. Install another adapter which is known to have no problem into a
second computer as instructed in Chapter 2.
2. Run SETUP.EXE on that computer.
3. Press [F10] and press [® ] to select "Diagnostics" from the main
menu.
4. Select "Connectivity Test" and press [Enter].
5. Select "Start Echo Station Test" from "Connectivity Test" pop-up
window and press [OK]. The computer becomes an echo
station. It will receive every packet with address 00 11 11 11 11
11 and echo the packets back to the adapter from which the
packets were sent.
You may start the Connectivity Test for the adapter after an echo
station has been set up. Follow these steps:
1. Press [PgDn] or [PgUp] to select the adapter you want to test.
2. Press [F10] and press [® ] to select "Diagnostics" from the main
menu.
3. To configure the number of packets to be performed for the
"Network Link Test" in step 4, you may select "Test Configura-
tion" item from the pop-up menu to enter the number:
15
Advertisement
Table of Contents
