Table of Contents
Advertisement
5.2.2 GPS data timer
For saving battery power, the device can be set to turn on at a predefined interval. It is set as below:
"00": the device turns on and receives GPS data continuously;
"01"-"99": the device will turn on automatically in every 1-99 minutes.
Note: Other input is regarded as the default value (00).
5.2.3 SMS timer
These two digits determine the interval at which the device sends the SMS automatically.
"00": the device doesn't send out SMS automatically;
"01"-"99": the SMS will be sent in every 1-99 minutes.
Note: Other input is regarded as the default value (00).
5.2.4 Temperature Alarm
When the device temperature reaches 50 degree, it will send a SMS to SOS numbers as the following format:
Temperature > 60C !
N,Lat:2242.9753,
E,Lon:11349.0237
Note: Set the 10th number for "1-9" : the device will check the temperature in every 1-9 minutes.
5.2.5 Geofence & Speeding Alarm
Once the tracker moves
out of the predefined
range, it will warn you up
by two SMS.
6 Operate
6.1 Device ON/OFF
Turn on: Press the power button, and then the Red and the Blue LEDs flash quickly and Green LED is on, after the startup
process is completed it will enter the standby mode with the Red and Blue LED flashing slowly and Green LED flashes
slowly.(During the startup, the tracker can not be turned off.)
Turn off: Press the power button for four seconds, and the Red and the Blue LEDs will flash quickly. When both of the LEDs
turn off, the device turns off for sure.
6.2 Geofence ON/OFF
ON
After the PT-9 works normally, double press the power button in 2seconds, then the Red LED will flash quickly. When the Red
LED changes to normally flash, it means that PT-9 has saved your current position. Now Geofence mode is ready, when the
user move out of the range that has preset in the parameters setting the tracker will warn user up by two SMS.
Weiom Technology Co., Limited
Once the tracker moves
exceeding the speed limit,
the device will warn you
up by two SMS.
Notes:
1) ONLY when you set GPS data timer at "00",
the speeding alarm works.
2) Speed alarm & Distance alarm will be sent to
the TIMER.
3) It is recommended that Speeding Alarm is set at
not less than 50km/h for a precise alarm, for below
that rate, it may cause drift or excursion of GPS
signal influenced by clouds etc.
7
Advertisement
Table of Contents
Troubleshooting
