Inquire About The Working Status; Set Up The Working Status - Weiom PT-9 User Manual

Notes:
1. For safety consideration, the SMS can not change the device password; these 6 digits in SMS must be same with the old
one which is pre-set on mobile phone. If the SIM card isn't pre-set before, the default value must be 000000.
2. In case of accident (such as PT-9 is in process of power-off when the SMS is sent out), this operation may cause the
parameter setting returns to the default value (including the password).

8.2 Inquire about the working status

8.3 Set up the working status

For GPS module:
The user can send a SMS command to turn on the GPS timer. The SMS command is as below:
The user can send "S,ROFF" to turn off the GPS timer.
For SMS sending:
The user can send a SMS command to turn off the SMS sending. The SMS command is as below:
The user can send "S,SON" to turn on SMS sending.
Weiom Technology Co., Limited
Confirm
Confirm
Confirm
The user can send a SMS command to inquire about
working status. The SMS command is as left:
GMT:+08:00 is the Time zone. GPS RT:00 GPS timer
is on. SMS ST:01 Send SMS location every 1 min. GPS
R:on GPS module is on. S Timer:off SMS sending is off.
T Alarm:5 Check temperature every 5 mins. Geo:08
Geofence is 400meters. SPD:08 Speeding Alarm is
80km/h. SPD:ON Speeding Alarm is on. GPRS:on
GPRS is on. Geofence:off
LF:GOOGLEMAP
GOOGLEMAP mode.
Geofence is
Location inquiry is
off.
in
10