2.5 First Startup
When you start the device for the first time, the initial initialisation (longer start) is
performed and indicated by the following LED notification sequence: Blue > Red >
Green > Boot animation on the screen > Introductory system screen.
The introductory screen provides essential information for User Manual saving/reading.
You can deactivate this screen for later startups.
The table below shows the factory values of relevant device parameters:
IP address
IP mask
IP gateway
Access password to configuration
Time/weather location
Stand-by switching time
SW licence
Caution
System Licence
®
2N
Indoor Touch
on the Part No.). The licence expiry may cause a partial limitation of the device
functionality! Refer to
licence adding procedure if necessary.
®
2N
TELEKOMUNIKACE a.s., www.2n.cz
Parameter
Change the access password while configuring the device for the first time
to avoid unauthorised access to configuration!
has a factory licence key, which can be time-limited (depending
3.3 Launcher Configuration
Value
will be assigned by the DHCP server
will be assigned by the DHCP server
will be assigned by the DHCP server
2n
Prague, CZ
1 minute
Basic unlimited licence
(or according to the Part No.)
for the current licence state and
16