Brief Installation Guide - 2N Indoor Touch User Manual

2.2 Brief Installation Guide

1. Install the device holder onto a vertical wall. The recommended installation
height is 120 cm above the floor. The product package includes screws and plugs
for mounting into classic bricks. Use appropriate installation fittings for a different
type of wall material!
2. Feed the device via an Ethernet PoE adapter (or PoE supporting Ethernet
switch/router) or a 12V DC 2A power adapter.
3. Put the device on the holder as follows:
4. Tighten the safety screws on both the device sides.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
a. With PoE supply, just snap RJ-45 into the appropriate connector.
b. With 12V DC 2A supply, screw the power adapter plus and minus cables
into the appropriate terminal board on the device.
c. Simultaneous PoE +
a. Place the device carefully from top to bottom with its bottom part slightly
away (up to 5 cm) from the wall.
b. When the device fits to the main holder supports, push the device bottom
part onto the wall.
12V DC 2A supply is not recommended !
12