Table of Contents
Advertisement
GETTING STARTED (CONT.)
Phone Light
Power Light
Power Switch:
Print Switch:
ELECTRONIC VOICE
The electronic voice is a single programmable voice message that is stored in the memory of your
TDD. The message is used for calling hearing people at VOICE/TDD number. The TDD will also
send your state's voice number, so the caller will know how to contact you. You must first program
this Voice Relay number by using [CTRL]+[K]. The voice message will be repeated until your TDD
conversation begins (when your TDD receives signals from another TDD or you type on the key-
board).
TO ENTER RELAY VOICE MESSAGE
The Memory Printer gives you one electronic voice message: "Please use TDD or Call through Relay.
X XXX XXX XXXX." To enter your relay voice and TTY number:
+
CTRL
RETURN
RETURN
CTRL
+
R
+
CTRL
SHIFT
10
Shows sounds heard on the telephone line.
Show status of power. When the light shows:
STEADY = Power is ON
FLASHING = Low battery power
NO LIGHT = Power is OFF
This switch turns the power ON and OFF
This switch turns the printer ON and OFF, it is not
available for MP2000DX and MP2000LD models. Turn printer
OFF and ON for these models by pressing [CTRL]-[P] instead.
K
TTY relay number's stored.
Voice relay number's stored.
To automatically dial the TTY relay number, press.
PLEASE WAIT.
DIALING XXX
Clears the relay number you have stored.
+
R
TTY RELAY NUM
VOICE RELAY NUM
CHECK FOR DIAL TONE
Advertisement
Table of Contents
