Before Starting; Market Codes; Writing Conventions Followed; Supplied Accessories - Kenwood TS-590SG Instruction Manual

BEFORE STARTING

Amateur radio regulations vary from country to
country. Confi rm your local amateur radio regulations
and requirements before operating the transceiver.
Depending on the size and type of vehicle, the
maximum transmission output power for the mobile
operation will vary. The maximum transmission output
power is usually specifi ed by the car manufacturer
to avoid interference with other electric devices used
in the vehicle. Consult your car manufacturer and
amateur radio equipment dealer for the requirements
and installation.

MARKET CODES

K-type: The Americas
E-type: Europe
The market code is shown on the carton box.
Refer to the specifi cations {page 86} for information on
the available operating frequencies.

WRITING CONVENTIONS FOLLOWED

The writing conventions described below have
been followed to simplify instructions and avoid
unnecessary repetition.
Instruction
Press [KEY].
Press Mic [KEY].
Press and hold [KEY].
Hold [KEY].
Press [KEY] + [ ].
ii
Action
Press and release KEY.
Press and release KEY on
the microphone.
Press and hold KEY down
for a moment, then release
KEY.
Press and hold KEY down
until instructed to release
KEY.
With the transceiver power
OFF, press and hold KEY,
then switch the transceiver
power ON by pressing [ ].

SUPPLIED ACCESSORIES

After carefully unpacking the transceiver, identify the
items listed in the table below. We recommend you
keep the box and packing materials in case you need
to repack the transceiver in the future.
Accessory Comment
Microphone
DC power cable
25 A; for DC
Fuse
power cable
4 A; for an
Fuse external
antenna tuner
7-pin (For
DIN plug REMOTE
connector)
13-pin
DIN plug (For ACC2
connector)
Screw set For bracket
Plastic spacer For bracket
English
French
Spanish
Instruction Manual
Italian
German
Dutch
Schematic
diagram
Warranty Card
Quantity
K-type E-type
1 1
1 1
1 1
1 1
1 1
1 1
1 1
4 4
1 1
1 1
– 1
– 1
– 1
– 1
2 –
1 1