Remote Controller Installation Guide - State Water Heaters Gas Water Heater Owner's Manual And Installation Manual

Optional Remote Controller
Installation Guide
Note
Do not connect power to the water heater before the remote controller has been properly
installed.
Included Parts List
Part Name
Remote Controller
Wall Packing
Phillips Roundhead Wood Screw
Wall Anchor
Do not disassemble the remote controller.
Notes on the Installation Location
• The remote controller can be installed at a
convenient place in the bathroom, because it
is waterproofed and of a low-voltage design,
but avoid installing in a place where water
may splash on the controller.
• Avoid locations where special chemical
agents (e.g., benzene, fatty and oily deter-
gents) are used.
• Avoid outdoor installation, or installation in an
indoor location where it will be exposed to
direct sunlight.
48
Wall Packing
Quantity
1
1
2
2
Remote Controller
Connection of Remote Controller Cord
White Connector
Y-shaped terminal
(two-core)
* Confirm the connection with the labels at
both ends of the remote controller cord.
• The remote controller cord can be ex-
tended up to 300 ft. by splicing the cord
and using 18 gauge wire to extend the
cord to the appropriate length.
For Installers:
Read this installation guide
carefully before carrying out
installation.
Connecting Wire
Phillips Roundhead
Wood Screw
Wall Anchor
Remote controller side
Water heater side