SA-PAM-SAN-Eth
7 TFTP UPLOAD
7.1 Unit preparation
Its suggested to connect the PC Terminal to the monitor connector for the observation of the
download procedure.
• Enter the Ethernet Setup submenu.
• Enter menu point [Enable TFTP Server] and switch TFTP on
• Exit menu point [Enable TFTP Server]
• Enter the Profile Submenu and Save the settings to Profile 0
• Restart the unit
7.2 PC Software download
• Unzip the download file to an empty directory
• If necessary rename the actual *.bin file to "all.bin"
• Open the cmd.exe windows menu (Start, Run, cmd)
• Enter the directory with the unzipped files
• Enter the following command "
• Wait until the program terminates (check it on the PC Terminal)
• Close the cmd.exe windows menu
7.3 Unit termination
• Enter the Ethernet Setup submenu.
• Enter menu point [Enable TFTP Server] and switch TFTP off
• Exit menu point [Enable TFTP Server]
• Enter the Profile Submenu and Save the settings to Profile 0
• Restart the unit
S-Access GmbH
Oberhausenstrasse 47
8907 Wettswil a/A
Switzerland
User Manual
TFTP –I xx.xx.xx.xx PUT all.bin"
25
32
Page
of
Tel: +41 44 700 31 11
Fax: +41 44 700 31 03
Email:
contact@s-access.ch
WEB:
www.s-access.ch