SA-PAM-SAN-Eth
5 RULES OF SWITCHING
5.1 The SAN (Stand alone) delivery set
The delivery set includes:
•
the subscriber access device (a modem)
•
the power supply source (an AC adapter)
•
the cables for the line connections
5.2 The SRL (SubRackCard) delivery set
The delivery set includes
•
the subscriber access device (a module)
•
the cables for the line connections
5.3 Connection rules
During the connection of the modem stick to the following rules:
•
connect
the
through the HUB connector or to the PC through the PC connector. Only one device can be
connected to modem jack at same time.
•
connect
the
modem,
the "MONITOR" connector using the "straight" modem cable;
•
connect the modem to the line using the "DSL" connector;
•
connect the power supply unit to the AC power system;
•
connect the modem to the power adapter using the "DC 12V" connector; it's necessary to
use 13.5V adapter for FXS models
•
launch the hyper-terminal operation program on the PC.
5.4 Communication parameters of the terminal configuration
It is necessary to set the following parameters to monitor the modem:
•
transmission rate – 9600;
•
data bits – 8;
•
parity – none;
•
number of stop bits – 1;
•
flow control – None
S-Access GmbH
Oberhausenstrasse 47
8907 Wettswil a/A
Switzerland
User Manual
modem
using
the
if
necessary,
"straight"
Patch
to
the
serial
14
32
Page
of
Cord
cable
to
port
of
the
PC
Tel: +41 44 700 31 11
Fax: +41 44 700 31 03
Email:
contact@s-access.ch
WEB:
www.s-access.ch
the
hub
through