Table of Contents
Advertisement
SA-PAM-SAN-Eth
Status(L)
informs the user about the status of the local device. The following four statuses are
possible
«blinking red»
«red»
«amber»
«green»
Status(R)
informs the user about the status of the remote device. At the time being the remote
configuring of modems is not provided.
Ethernet
The LED is lit upon an incorrect connection to the LAN. The LED is blink upon the
detection of packets in the segment of the current LAN.
S-Access GmbH
Oberhausenstrasse 47
8907 Wettswil a/A
Switzerland
User Manual
informs the user about malfunctioning of the modem's hardware and
software. In this case, the modem is out of order and should be
submitted to the service center for being repaired.
informs the user about an urgent alarm. An abruption of the
connection, the correspondence of the signal-to-noise ratio which
does not allow to transmit information and a great number of errored
blocks can cause an urgent alarm.
informs the user about non-urgent alarms. An abruption of
connection over the user's interface can cause non-urgent alarms.
absence of alarms. Normal functioning of the device.
13
32
Page
of
Tel: +41 44 700 31 11
Fax: +41 44 700 31 03
Email:
contact@s-access.ch
WEB:
www.s-access.ch
Advertisement
Table of Contents
