Alcatel Speed Touch Pro User Manual page 171

Configuring the STPro
for LIS connectivity,
advanced
Configuration your LAN
PCs for end to end
connectivity
Routing table
configuration
3EC 17059 AAAA TCZZA Ed. 01
The possibility exists to add routes yourself, e.g. to be more
specific in the source IP address pool.
The default added routes have any as source address, meaning
that all local hosts can use this gateway to connect to the LIS via
the CIP interface.
However, you might want to embed restrictions in LIS access by
creating a subnet in your LAN, e.g. 10.0.1.x, and privilege access
to the LIS - and its beyond LAN - to this subnet by adding a
route, pointing to the remote access router (implicit, or explicit),
but with source IP address pool 10.0.1.0/24.
Of course, then the default IP routes, configured by default, must
be deleted.
In order to have end to end connectivity from your PCs to the
remote side of the CIP connection and beyond, you must add
routes having the
By specifying 0.0.0.0/0 as destination, and the
Ethernet IP address as gateway, the
default gateway for all connection requests.
However, you can specify a destination IP address pool; e.g. if the
remote LAN's IP subnetwork is 192.6.11.x, you can add routes in
your PC's routing table with destination 192.6.11.0/32, and the
as gateway.
Configuring routes for the
11.5.2.
Configuring routes for your PCs, running Windows OSs, is
described in subsection 11.5.3.
9 IP Routing & Classical IP
Ethernet interface IP address as gateway.
is configured as the
is described in subsection
local
171 / 340