Safety Instructions; Preparing Your Unit For Use - CleanFreak CF-3 Owner's Manual

Follow these basic precautions when using your Carpet Spot
Extractor:
1. Do not operate this unit if any part of the unit appears damaged.
2. Do not operate if ground plug is broken.
3. Do not operate if the unit is in standing water.
4. Do not use volatile substances or operate when volatile substances exist.
5. Do not service while unit is running or connected to electricity. Unplug the unit!
6. Do not use water more than 120 degrees Fahrenheit.
7. Do not use solvents with this unit.
8. Do not use as a dry vacuum.
9. Do not use unit unless completely assembled.
10. Use only liquid detergents. Powders do not fully dissolve and damage motor.
11. Always use defoamer. Foam will suspend moisture particles that damage motor.
1. All extractors—no matter what the time of year—are shipped with antifreeze in the pump and
solution lines. Prior to first use, fill the tank with one quart of warm water. Attached the hoses
and using the hand tool, flush out the system by spraying the one quart of water through the
pump.
2. Attach the 1-1/2 inch vacuum hose and the brass quick disconnect.
3. Fill the base unit (the recovery tank must be removed) with warm water (less than 100
degrees Fahrenheit). Fill to approximately 4 inches from the top. Use a liquid detergent made
for carpet cleaning or upholstery. Read and mix to the dilution ratios as directed.
IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ AND SAVE!
WARNING!
PREPARE UNIT FOR USE
Page 4
CF-3 CleanFreak Spotter
3-Gallon Carpet Spot Extractor
100 CFM / 800 Watt Motor