Removing The Refrigerator Doors; Accessories/Required Tools - Samsung RF4267HA User Manual

• Do not locate the refrigerator where it may become
wet.
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above
CAUTION
the fl oor).
Refer to 'Adjusting the doors' in the manual (on
page 9).
Flat-blade Flat-blade
Control Lever Control Lever
screw driver(-) screw driver(-)
FLOORING
For proper installation, you must place this refrigerator
on a level, hard surface that is the same height as the
rest of the fl oor. This surface should be strong enough
to support a fully loaded refrigerator, or approximately
359lbs (165kg). To protect the fi nish of the fl ooring, cut
a large section of the cardboard carton and place it
under the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES AND REQUIRED
TOOLS
The following accessories are included with your
refi gerator:
Hex wrench Fastener
06_ setting up
Required Tools (Not provided)
You need the following tools to complete the
installation of your refi rgerator:
Philips screw- Flat-blade screw-
driver (+) driver (-)
Pliers Allen wrench (3/16") (5mm)
REMOVING THE REFRIGERATOR
DOORS
For some installations you need to remove the fridge
and fl ex doors and the freezer drawer so you can
move the refrigerator to its fi nal location. Do not
remove the doors/drawer if you don't need to. If you
do not need to remove the doors/drawer, go to
Adjusting the Level on page 8. If you need to remove
the doors/drawer, continue below.
Before removing the door/drawer, make sure you read
the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors
while removing the doors.
WARNING
Disassemble the refrigerator doors
1. With the door opened, remove the cap top table
( 1 ) with a fl at-blade screwdriver(-). and close
the door. Remove 2 screws holding down the
cover hinge ( 2 ) and turn it with several wires
connected.
Socket wrench
(10mm)