Jenn-Air W10297654A Installation Manual page 24

4. French door models, repeat steps 1 through 3 to install the
second door panel.
5. Using a slotted hex head screw (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator door(s), to the respective door
panel(s). Do not fully tighten the screw.
A
A. Bottom hinge
B. Mounting bracket
Install Drawer Panel
1. Align the slots in the door panel brackets, located on each
side of the drawer panel, with the holes that go through the
drawer trim and into the drawer.
2. Using Phillips head flat screws (provided with refrigerator),
attach the brackets to the drawer.
3. Move the drawer panel up and down or from side to side to
align. Do not fully tighten the screws.
A
B
A. Drawer overlay panel
B. Drawer panel bracket
24
Standard Installation - Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
B
2. Pull the grille panel down slightly to lock into place.
Integrated Installation - Full Height Grille
1. Align the bracket on each side of the top grille panel with the
2. Push the grille panel forward until the bracket snaps into
It may be necessary to adjust the swing of the door(s). Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
Install Top Grille Panel
B
A. Top grille panel
B. Cabinet sides
from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
mounting bolts.
place.
Door Swing Adjustment
A B
A
B