HIKVISION DS-2CD883F-EW Installation Manual page 31

Installation Manual of Network Camera
3. Loosen the set screws with the hex key (supplied) to remove the lower dome; remove the dome
liner.
4. Install the dome module to the back box and pull the cables through the cable outlet on the
bottom of the back box.
Note: If you need to pull the cable through the cable outlet from the side of the camera, please
remove the cover and use water-proof joints and water-proof pipe to route the cables.
Figure 3-32 Secure the Back Box
Figure 3-33 Remove the Lower Dome
24