Sharp AR-5618 Service Manual page 64

C. Thermistor
Installation: Install in direction that the sponge side (A) of the thermistor
comes in contact with heat roller.
Check that the thermistor is in contact with the upper heat
roller.
(1)
(2)
D. Heater lamp
Assembly: Insert the spring (A) into the hole (B) in the fusing frame.
(1)
(3)
(2)
(1)
(3)
(1)
(2)
(A)
(B)
(A)
(3)
(1)
(2)
AR-5618S DISASSEMBLY AND ASSEMBLY 10-5
Assembly: Put the fusing harness (A) on the heater lamp (B) as shown
in the figure and fix them together.<R>Place the fusing
harness inside the rib (C).
E. Upper heat roller
Disassembly: There are three pawls on the fusing cover. Remove the
screws and slide the fusing cover to the right to remove.
The heater lamp is fixed on the fusing cover with a
screw. Slide the fusing cover to the front and remove the
screw, then remove the heater lamp.
(2)
(1)
(3)
(1)
(2)
(2)