Black & Decker SS1000 Linea PRO Instruction Manual page 10

ENGLISH
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power tool
for operations different from those intended could result
in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
6. Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be
replaced by the manufacturer, authorized Black & Decker
Service Center or an equally qualified person in order
to avoid damage or injury. If the power cord is replaced
by an equally qualified person, but not authorized by
Black & Decker, the warranty will not be valid.
7. Labels on tool
The label on your tool may include the following symbols:
Read Instructions Manual
Use Eye Protection
Use Ear Protection
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
........ Alternating Current
Additional safety instructions for sanders
Warning! Contact with or inhalation of dusts arising
from sanding applications may endanger the health of the
operator and possible bystanders. Wear a dust mask
specifically designed for protection against dust and
fumes and ensure that persons within or entering the
work area are also protected.
Thoroughly remove all dust after sanding.
Take special care when sanding paint which is possibly
lead based or when sanding some woods and metal
which may produce toxic dust:
10
........ Direct Current
n .......... No-Load Speed
0
........ Class II Construction
........ Earthing Terminal
........ Safety Alert Symbol
.../min.... Revolutions or Reciprocation
per minute
- Do not let children or pregnant women enter the work
area.
- Do not eat, drink or smoke in the work area.
- Dispose of dust particles and any other debris safely.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-on button
3. Dust extraction outlet
4. Sanding base
5. Paper clamp lever
6. Variable speed control knob
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding sheets (fig. A)
Warning! Never use the tool without a sanding sheet or
accessory in place.
Soften the sanding sheet by rubbing its non-abrasive side
over the edge of a worktop.
Release the sanding sheet clamp levers (5).
Place the sheet onto the sanding base (4), making sure that
the holes in the sheet line up with the holes in the base.
Insert the edge of the sanding sheet into the front paper
clamp as shown.
Press the front paper clamp lever (5) downwards.
While keeping a slight tension on the sheet, insert the
rear edge of the sheet into the rear paper clamp.
Press the rear paper clamp lever (5) downwards.
Fitting and removing the dustbag (fig. B)
Fit the dustbag (7) over the dust extraction outlet (3).
Rotate the dustbag to lock it into position.
To remove the dustbag, proceed in reverse order.
Connecting a vacuum cleaner (fig. C)
Insert the adaptor (8) into the dust extraction outlet (3).
Connect the hose (9) of the vacuum cleaner to the adaptor.
Use
Warning! Let the tool work at its own pace. Do not overload.
Variable speed control
The variable speed control allows you to adapt the speed of
the tool to the workpiece material.
Set the control knob (6) to the desired setting. Use a high
speed for wood, medium speed for veneer and synthetics
and low speed for acrylic glass, non-ferrous metals and
for removing paints.