Ii-6. Wps Setup; Ii-7. Reset To Factory Default Settings - Edimax EW-7208APC User Manual

II-6. WPS Setup
If your wireless device supports WPS (Wi-Fi
Protected Setup) then you can use this
method to connect to the
Wi-Fi network.
1.
Press the WPS button on the EW-7208APC
for 2 – 5 seconds to activate WPS. The
WLAN LED will be lighted on to indicate
that WPS is active.
2.
Within two minutes, press the WPS
button on the wireless device/client to
activate its WPS.
3.
The devices will establish a connection.
Repeat for additional wireless devices.
Please check the instructions for your wireless device for how long
you need to hold down its WPS button to activate WPS.
II-7. Reset to Factory Default Settings
If you experience problems with your EW-7208APC, you can reset the device
back to its factory settings. This resets all settings back to default.
1.
Press and hold the WPS/Reset button found on the back panel for at least
10 seconds, until the power LED begins to flash.
2.
Release the button when the power LED is flashing.
3.
Wait for the EW-7208APC to restart. The EW-7208APC is ready for setup
when the power LED, 2.4GHz Wi-Fi and 5GHz Wi-Fi LEDs display on.
EW-7208APC
's