REMOVAL & INSTALLATION
1.
Disconnect the negative battery cable.
2.
Label and detach all wiring from the ignition coil.
3.
Remove the ignition coil−to−bracket bolts, then remove the ignition coil.
4.
If necessary, at this time the radio ignition interference capacitor can be removed from the ignition
coil.
To install:
5.
If necessary, install the radio interference capacitor onto the ignition coil. Tighten the mounting bolt
to 25−35 inch lbs. (2.8−4.0 Nm).
6.
Position the ignition coil onto the mounting bracket, then install and tighten the mounting bolts to
25−35 inch lbs. (2.8−4.0 Nm).
7.
Attach all wiring to the ignition coil, then connect the negative battery cable.
Ignition Control Module (ICM)
REMOVAL & INSTALLATION
Remote Mounted Module
180
HOW TO USE THIS BOOK
Ignition coil secondary resistance test
REMOVAL & INSTALLATION