Receiver Operation; Sound Control; Source Selection; Surround Mode - Sherwood R-125 Operating Instructions Manual

RECEIVER OPERATION

POWER ON/OFF
Depress the POWER switch to turn on the Receiver.
– The receiver will enter the standby mode and the standby indicator will light up
When the receiver is switched to active mode (as described below in the sections titled 'Wake-up from standby' and
'SOURCE SELECTION'), the respective indicators light up and the standby indicator is switched off.
To switch the receiver off depress the POWER switch again.
STANDBY
Switching the R-125 or your whole system to standby can only be done using the remote control.
Switching a single source (e.g. CD) to standby
Select the source using the source button on the remote control.
Press the POWER button briefly.
– The selected source will be switched to standby.
Switching the whole system to standby
Keep the POWER button pressed for more than 1 second.
– The whole system will be switched to standby.
– All light indicators will be switched off with the exception of the standby indicator on the receiver.
NOTE : If the whole system is switched to standby when a recording is active, the recording (or CD-dubbing) will be
cancelled.
Wake-up from standby
Press POWER or select a source with your remote control.
– The system will switch from standby to the operating mode.

SOUND CONTROL

Volume
Adjust the sound volume with the MASTER VOLUME
control.
Balance
Press BALANCE.
– BAL(ance) lights up.
Adjust the stereo balance between the left and the right
channels with the BALANCE (
Treble
Press TREBLE.
– TRBL lights up.
Adjust the high tones with the TREBLE (
from MIN to MAX.
Bass
Press BASS.
– BASS lights up.
Adjust the bass tones with the BASS (
MIN to MAX.
WARNING : Extreme settings at high volume may
damage your loudspeakers!.
Use the SURROUND MODE buttons to select the
desired sound effect:
3 STEREO, SIMULATED, THEATER or HALL
Press MUTE on the remote control if you want to
decrease the volume quickly.
Press again to return to normal volume level.
Press FM MODE if you prefer mono reception.
Press again to return to stereo operation.
8
)
) control
) control from
PRO LOGIC,

SOURCE SELECTION

When the receiver is switched on, it will switch directly to
operating mode as soon as a source is selected.
– The receiver and the selected source will become active.
– The selected source will be indicated on the display.
You can also switch both the source and the receiver to
the active mode by simply pressing PLAY on CD, Deck
or one of the tuner preset buttons.
Source selection using the remote-control handset
Press (for more than 1 second) the respective source
button on the remote control.
– The selected source and the receiver will become active.
When the TAPE MONITOR button is depressed, or
selected via the remote control, only the component that
is connected to the "TAPE" jacks can be heard. The
TAPE MONITOR must be switched off in order to hear
any other source.

SURROUND MODE

With the SURROUND MODE buttons you can select 5
different surround modes:
STEREO, SIMULATED, THEATER, HALL, OFF.
PRO LOGIC, 3