Sleep; Dubbing From Vcr2 To Vcr1 - Sherwood R-125 Operating Instructions Manual

SLEEP

The sleep mode allows the system to continue to operate for
a specified period of time before automatically shutting off.
Press the SLEEP button on the remote control.
– The display shows the indication SLEEP 10.
– This means that the system will be switched to standby
after 10 minutes.
Select the required sleep time by pressing SLEEP : 10,
20, 30, 60 or 90 minutes.
Notes:
– During an active sleep timer period, you can reset the
time to SLEEP 10 again by pressing the SLEEP button.
– A sleep timer period will be cancelled when you switch
your system to standby (using the POWER button on your
remote control).

DUBBING FROM VCR2 TO VCR1

Select VCR2 as program source to be recorded.
Start recording on the VCR connected to VCR1.
Start playback on the VCR connected to VCR2.
– The audio and video signals from VCR2 will be dubbed
onto the tape in VCR1.
When dubbing from VCR2 to VCR1, you can replace the
audio signal from VCR2 with the signal from an audio
source, e.g. a CD player.
First select VCR2 as program source to be recorded.
Then select the requeired audio source.
Start recording on the VCR connected to VCR1.
Start playing back on the audio alternate source and
video on the VCR connected to VCR2.
– You can now watch the picture from VCR2 on your TV
and listen to the sound from the audio source while
recording.
RECEIVER OPERATION (CONT'D)
MODEL
POWER AMPLIFIER SECTION
POWER OUTPUT (8 Ohms)
STEREO MODE (20Hz-20kHz)
THD
IM DISTORTION
POWER OUTPUT (8 Ohms)
SURROUND MODE (LEFT, CENTER, RIGHT)
REAR
PREAMPLIFIER SECTION
INPUT SENSITIVITY/IMPEDANCE
PHONO (47K Ohms)
LINE (CD, TAPE, VIDEO, @ 47K Ohms))
SIGNAL TO NOISE RATIO
PHONO
LINE (CD,TAPE,VIDEO)
TONE CONTROLS
BASS (100Hz)
TREBLE (10kHz)
CINEMA BASS
BASS @ 80Hz LEFT /RIGHT, CENTER
FREQUENCY RESPONSE
PHONO (20Hz-20kHz,RIAA)
LINE (CD, TAPE, VIDEO, 10Hz-100Hz)
FM TUNER SECTION
USABLE SENSITIVITY (MONO)
50dB QUIETING SENSITIVITY
MONO
STEREO
SIGNAL TO NOISE RATIO @ 65dBf,MONO/STEREO
THD @ 65dBf, 1kHz, MONO/STEREO
FREQUENCY RESPONSE (30Hz-15Hz)
STEREO SEPARATION (1kHz)
CAPTURE RATIO
ALTERNATE CHANNEL SENSITIVITY ( @ 98MHZ, +/-400Hz)
IMAGE REJECTION RATIO
IF REJECTIOR RATIO
SPURIOUS REJECTION RATIO
AM TUNER SECTION
USABLE SENSITIVITY (400u V/m)
SIGNAL TO NOISE RATIO
SELECTIVITY
DIMENSIONS and WEIGHTS (Unit)
HEIGHT (INCHES)
WIDTH (INCHES)
DEPTH (INCHES)
WEIGHT (LBS)
MAINTENANCE
Do not leave the unit in direct sunlight or other places
where high temperatures can occur for any length of time,
such as in the vicinity of a heating source.
Do not expose the equipment to humidity or rain.
A chamois leather cloth, slightly moistened with water is
sufficient for cleaning the cabinet.
Do not use cleaning agents containing alcohol, spirits,
ammonia or abrasives.
R-125
70W x 2
0.05%
0.05%
60W x 3
60W
2.5mV
150mV
75dB
100dB
+,-10dB
+,-10dB
+,-0.5dB
+0,-1.5dB
10.8dBf
16.2dBf
38.1dBf
77dB/71dB
0.2%/0.3%
+,-1dB
45dB
2dB
55dB
50dB
75dB
65dB
12.5uV
48dB
25dB
5 5/8
17 3/8
11 7/8
11