Troubleshooting - Electrolux ELM 5250 User Manual

Troubleshooting

Problems
EN
The machine does not turn on.
The pump is very noisy. Both indicator
lights for small and big cups are flash-
ing. No water flow.
The loading lever doesn't reach the
brewing position.
The co ee is cold.
The co ee is brewed too fast, the
brewed co ee is not creamy.
Co ee is not brewed or brewed in
drips only.
Hot water / steam is not dispensed.
The milk does not froth.
The machine requires a lot of time to
heat up.
7
Causes
The machine is not connected to the
power source.
No water in the tank.
Capsule inserted incorrectly.
Capsule already used.
Co ee spout is clogged
Circuit is not primed
Hot water / steam spout is clogged.
Not suitable milk.
The milk is too hot.
The hot water / steam spout is clogged.
The machine has limescale build up.
Solutions
Connect the machine to the power source.
Contact Electrolux customer service.
Fill the tank with fresh drinking water.
1. Prime the water circuit.
2. Check correct water tank position.
Empty the used capsule compartment.
Repeat the sequence, open and close the lever. If
that is not enough remove the capsule manu-
ally from the compartment after unplugging the
machine.
Preheat the cup with hot water.
Open the lever and insert a new capsule.
Clean the co ee spout.
Prime the water circuit.
Clean the steam spout with a needle (the machine
needs to be unplugged and the steam / hot water
knob needs to be closed).
Use fresh, partially skimmed milk.
Use milk at refrigerator temperature.
Clean the steam spout with a needle (the machine
needs to be unplugged and the steam / hot water
knob needs to be closed).
Descale the machine.