Installing The Chute Control Rod - Toro Power Max Heavy Duty 826 OXE Operator's Manual

Figure 12
1. Speed selector lever
2. Trunnion
Note: To make installation easier, leave the flat washer
on the trunnion (Figure 12).
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 13).
Figure 13
6. Lift up on the speed control rod and insert the trunnion
into the hole in the speed selector lever (Figure 12).
Note: If the trunnion does not fit into the hole
when you lift up on the speed control rod, rotate the
trunnion upward or downward on the speed control
rod until it fits.
7. Secure the trunnion and upper end of the speed control
rod with the outer washer and a hairpin cotter you
previously removed.
3. Inner washer
4. Outer washer
Note: For easier installation, look down through the
opening in the speed selector (Figure 14).
1. Speed selector
4
Installing the Chute Control
Rod
Parts needed for this procedure:
2 Carriage bolts
2 Locknuts
Procedure
1. Unwrap the Quick Stick and rotate it so that it is
upright and in the center.
2. Hold the blue trigger cap down and pull the lever fully
rearward.
Note: The discharge chute and deflector should face
forward. If they do not, hold the blue trigger cap
down (but do not move the Quick Stick) and rotate the
discharge chute until they do.
3. Align the flattened back end of the long chute control
rod with the flattened front end of the short rod
that extends from the control panel so that they nest
together (Figure 15).
10
Figure 14