Connecting The Speakers - Yamaha A-S3000 Owner's Manual

Connections

■ Connecting the speakers

1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
10 mm (0.4 in)
2
Unscrew the knob and then insert the bare
wire into the hole.
3
Tighten the knob.
Caution
• When loosening the knob of the speaker terminal, do not rotate
it excessively. The knob may come off and pose the danger of
being swallowed by a child.
• Touching the speaker terminal with a metallic rack may cause
short circuit and damage this unit. When installing the unit in a
rack, maintain a sufficient clearance to prevent the speaker
terminals from touching the rack.
• To reduce the risk of electric shock, do not touch the speaker
terminal when the unit is turned on.
18
En
Hole for speaker cable:
6.0 mm (0.24 in) dia.
■ Connecting the banana plug
(Except for Europe models)
First, tighten the knob and then insert the banana
plug into the end of the corresponding terminal.
Banana plug
■ Connecting the Y-shaped lug
1
Unscrew the knob and then sandwich the Y-
shaped lug between the ring part and base.
Slide
Terminal screw for Y-shaped
lug: 5.0 mm (0.20 in) dia.
2
Tighten the knob.
Hole for banana plug:
5.5 mm (0.22 in) dia.
Y-shaped lug