Download Print this page

Warranty; Copyright, Trademarks - Pro-Ject Audio Systems Box-Design MaiA S3 Instructions For Use Manual

Advertisement

Technical specifications Pro-Ject MaiA S3
Power output:
Frequency response (20Hz-20kHz):
Channel separation:
Signal to noise ratio PA output:
Signal to noise ratio Variable output:
THD:
Headphone amplifier output:
Line level inputs:
Line input impedance:
Line input gain:
Phono input:
Phono input sensitivity:
Phono input impedance:
Phono input gain:
S/PDIF coaxial input:
S/PDIF optical input:
Digital to Analogue converter:
Variable line level output:
BT version:
BT music receiver codec:
BT maximum TX power:
Speakers connectors:
Headphone output:
Outboard power supply:
Power consumption in standby:
Replacement battery remote control:
Dimensions W x H x D (D with sockets): 206 x 55 x 153 (176) mm
Weight:
Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only if the problem cannot be resolved there, the unit should be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2022. All rights reserved.
BT®, aptX and aptX HD are trademarks owned by the BT SIG Inc., Microsoft®, Windows®, are either
registered trademarks or trademarks of Microsoft Corporation, Apple is registered trademark of Apple Inc.,
Android™ is a trademark of Google Inc.
2x 23W/40W at 8 ohms/4 ohms (1%THD)
<- 0,5dB (@4ohm)
- 69dB at 10kHz
97dB (101 dB - 'A' weighted) at 4ohm
103dB (105 dB - 'A' weighted)
< 0,04% at 10W / 4 ohms
2x 75mW at 32ohm (1%THD)
3 pair RCA (sensitivity: 270 mV)
50kohms
33,5dB
1 pair RCA
suitable for MM, MI or high output MC cartridges
47kohms
46dB
up to 24bit and 192kHz
2 inputs - up to 24bit and 192kHz
Cirrus Logic CS4344 24bit/192kHz Multi-bit Delta Sigma type
1 pair RCA
5.0
aptX, aptX HD, A2DP profile
+4dBm
∅ 4mm banana plugs, spades connectors or naked wire
6,3mm jack (16 – 600ohms)
20V/3A DC, suitable for your country's mains supply
<0.5W
1 x CR2032 / 3V or 1 x CR2025 / 3V
1070 g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
© Pro-Ject Audio Systems · MaiA S3 · Revision 2022.01.03
5

Advertisement

loading

This manual is also suitable for:

Box design s3 bt