Lcd Monitor Brightness; Auto Power Save; Instant Playback - Konica Minolta DiMAGE Z2 Instruction Manual

Konica minota dimage z2 digital camera instruction manual

Table of Contents

LCD monitor brightness

Monitor brightness can be adjusted in 11 levels.

Brightness can be set individually for viewfinder and

direct viewing in the recording mode. Turn the mode

switch to the appropriate position before opening the

brightness option in section 1 of the setup menu (p. 88).

Also see page 28.

Use the left/right keys of the controller to adjust bright-

ness, the monitor image changes accordingly. Press the

central button of the controller to set the level.

To conserve battery power, the camera will shut down if no operation is made within a certain peri-

od. The length of the auto-power-save period can be changed to 1, 3, 5, or 10 minutes. When the

camera is connected to a computer, the auto-power-save period is fixed at ten minutes. Auto power

save is set in section 1 of the setup menu (p. 88).

An image can be displayed on the monitor after it is captured. When

used with the continuous-advance or progressive-capture drive

modes (p. 46), the images in the series are played back in a six-

frame index display. Instant playback is activated section 1 of the

setup menu (p. 88). A playback period of two or ten seconds can be

selected. To cancel the playback and save the image before the end

of the playback period, press the shutter-release button partway

down.

Camera Notes

Single still images can be previewed immediately after being captured without instant playback

active. Simply continue to hold the shutter-release button down after taking the picture to dis-

play the image. Release the shutter button to end the playback.

ETUP MENU

Set LCD brightness

Low

High

:adjust

:enter

Table of Contents

Show Quick Links

Table of Contents