Table of Contents
Advertisement
To reinstall a cargo panel:
1. Starting with cargo panel 1,
place the latches in the unlocked
position. Place cargo panel 1 on
the cargo area rails while
holding the back of the cargo
panel up.
Driver Side Shown, Passenger
Side Similar
2. Place the cover on the cargo
box within 10 cm (4 in) of the
Midgate and lower the rear of
the panel within 5 8 cm (2 3 in)
from the top of the cargo box.
Push the cover forward making
sure that the guide block
engages the retainer bracket
opening. Continue to push
forward until the panel is fully
seated against the Midgate.
I n f o r ma t i o n P r o v i d e d b y :
Storage
Then lower the rear of the cover
to engage the striker pegs (A) to
align with the striker
assembly (B).
3. The driver side cargo cover
panel latch must lock in place
before the passenger side latch
can be locked. If this procedure
is not followed exactly, the cargo
cover panels might not correctly
lock in place. Push the driver
side latch toward the front of the
vehicle to lock the cover in
position. A click sounds when
4-9
Advertisement
Chapters
Table of Contents
