Biostar K8NHA-M Grand User Manual page 12

BIOSTAR Motherboard
(2) System Fan Headers: JSFAN1/JSFAN2
3. Installing DDR Module 3. Installing DDR Module 3. Installing DDR Module
3. Installing DDR Module 3. Installing DDR Module
1. Unlock a DIMM slot by
2. Insert the DIMM firmly and
7. How to set up Jumpers? 7. How to set up Jumpers?
7. How to set up Jumpers? 7. How to set up Jumpers? 7. How to set up Jumpers?
on pins, the jumper is "close". IF no jumper cap is placed on the pins, the jumper is
"open". The illustration shows a 3-pin jumper whose pin1and 2 are "close" when
jumper cap is placed on these 2 pins.
8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots:
8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots:
(1) Floppy Disk Connector: FDD1
12 12 12 12 12
English English
English English English
Pin Assignment
1 Ground
2 +12V
3 FAN RPM Sense
pressing the retaining clips
outward. Align a DIMM on the
slot such that the notch on the
DIMM matches the break on
the slot.
vertically into the slot until the
retaining chip snap back in place
and the Dimm is properly
seated.
The illustration shows how to set up jumpers. When the Jumper cap is placed
Jumper open
The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.
Jumper close
1
Pin1-2 close