PEUGEOT RCZ Handbook page 179

CHARGING THE BATTERY USING A BATTERY
CHARGER
 Disconnect the battery from the vehicle.
 Follow the instructions for use provided by the manufacturer of the charger.
 Reconnect starting with the negative terminal (-).
 Check that the terminals and connectors are clean. If they are
covered with sulphate (whitish or greenish deposit), remove them
and clean them.
DISCONNECTING / RECONNECTING THE
CABLES
 Raise the locking tab D fully.
 Position the open clip E of the cable on the positive terminal (+)
of the battery.
 Press vertically on the clip E to position it correctly against the
battery.
 Lock the clip by lowering the tab D .
Do not force the tab as locking will not be possible if the clip is not
positioned correctly.
Start the procedure again.
To avoid discharging the battery, do not leave the vehicle lighting
on repeatedly with the ignition off (refer to the "Energy economy
mode" paragraph).
It is advisable to disconnect the battery if the vehicle is to be left
unused for more than one month.
Do not disconnect the terminals while the engine is running.
Do not charge the batteries without disconnecting the terminals fi rst.
Before disconnecting the battery
Wait 2 minutes after switching off the ignition before disconnecting
the battery.
Retract the active spoiler then close the windows and the doors
before disconnecting the battery.
Following reconnection of the battery
Following reconnection of the battery, switch on the ignition
and wait 1 minute before starting to permit initialisation of the
electronic systems. However, if slight problems remain following
this operation, contact a PEUGEOT dealer or a qualifi ed
workshop.
Referring to the corresponding section, you must yourself
reinitialise:
- the remote control key,
- the electric windows and the automatic partial opening of the
door windows,
- the GPS satellite navigation system.
Some functions are not available if the battery is not suffi ciently
charged.