Parts, Tools, Materials - Sears 721.80513 Installation Instructions Manual

THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation)
One power cord clamp bushing (for the cord hole in a metal upper cabinet)
Four 1/4" x 2" lag screws
(for wall stud holes)
Two 1/4" x 3" bolts
(for securing to the upper cabinet)
Four spring toggle heads
(for the toggle bolts)
One rear wall template
(3 pieces mounting plate only)
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the wall venting
cutout. Do not use this template for roof
4
or room venting.
1. Place the template flat against the rear
wall, aligning circles A and B with the
corresponding holes previously drilled in the
2. With the template aligned to the holes, tape the rear wall for holes A and B of the wall plate.
template to the rear wall.
3. Use a saber or keyhole saw to cut out the shaded
A.
area F through the rear wall.
4. Remove the template from the rear wall.
LINE UP WITH 5. RETURN TO AND PROCEED WITH THE
PREVIOUSLY INSTALLATION INSTRUCTIONS.
DRILLED HOLE
REAR WALL TEMPLATE
Printed in Korea
P/N. 4922W5A060A
NOTE: You need to install at least one lag screw into a 2" x 4" stud and four anchor bolts into the wall,
and the mounting area must meet the 150 lbs. weight requirement.

PARTS, TOOLS, MATERIALS

1/4
12
F. CUT OUT FOR WALL
VENTED ONLY
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
B.
LINE UP WITH
PREVIOUSLY
DRILLED HOLE
CAUTION — IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE.
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Four 1/4" x 3" toggle bolts
(for drywall holes)
Two tapping screws
(for attaching the damper duct connector)
One upper cabinet template
5