Parts, Tools, Materials - Sears 721.80513 Installation Instructions Manual

PARTS, TOOLS, MATERIALS
THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation)
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
One power cord clamp bushing (for the cord hole in a metal upper cabinet)
Four 1/4" x 2" lag screws
(for wall stud holes)
Four 114"x 3" toggle bolts
(for drywall holes)
63
Two 1/4" x 3" bolts
(for securing to the upper cabinet)
Four spring toggle heads
(for the toggle bolts)
One rear wall template
(3 pieces mounting plate only)
Two tapping screws
(for attaching the damper duct connector)
One upper cabinet template
I
REAR WALL TEMPLATE I
NOTE: You need to install at least one lag screw into a 2" x 4" stud and four anchor bolts into the wall,
and the mounting area must meet the 150 Ibs. weight requirement.