Technical Data; Recommendation Of Cleaning Method; End Of Operation - Challenge 1500W High Pressure Washer Instruction Manual

CARE & MAINTENANCE

Recommendation of cleaning method

1. Wash away any loose dirt by high pressure jet.
2. Spray on the detergent and leave it for a few minutes for easy removal of fine
dirt and greasy adhesions.
3. Spray off the loosened dirt with the high pressure spray.
NOTE: For any surface intended to be cleaned with rotary brush or standard
brush, always spray off any loose dirt and solid particles using a high
pressure jet.

End of Operation

- After cleaning-using the detergent, remember to empty the detergent container
and rinse your pressure washer by running the pump for one minute on the low
pressure setting.
1. Switch off the pressure washer and disconnect from the mains.
2. Close the water inlet (tap) and disconnect the hosepipe.
3. Squeeze the trigger switch to release all pressure from the machine and secure
the trigger with the safety locking device to prevent accidental opening during
the next time of operation.
4. Completely empty the water from the machine.
IMPORTANT :
Remember frost will damage your Pressure Washer if it has not
been completely emptied of water after use. Always store in a frost free
area, frost damage is not covered by the warranty.
WARNING :
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
12

TECHNICAL DATA

Technical Data
Voltage 230-240V~
Power input 1500W
Operating pressure 5.5 Mpa
Permissible Pressure 10 Mpa
Water consumption 5.5 L/min
Noise and Vibration Data
Measured sound pressure level: Lp=94dB
Guaranteed sound power level according to 2000/14/EC : Lw=98dB(A)
Vibration : < 3.0 m/s2
Connecting to Power
Check that the voltage marked on the product corresponds with your supply voltage.
This product is fitted with a 13A plug complying with BS1363. If this plug is unsuitable
or needs to be replaced, please note the following :
Plug Replacement
If you need to replace the fitted plug.
WARNING :
Never connect live or neutral wires to the earth terminal of the plug.
Only fit an approved 13 Amp BS1363/A plug and the correct rated fuse.
If in doubt, consult a qualified electrician.
IMPORTANT
The wires in this mains lead are coloured as follows:
Blue-Neutral
Brown-Live
As the colours of the wires in the mains lead of this
apparatus may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected
to the terminal, which is marked with N or coloured blue. The wire which is coloured
brown must be connected to the terminal which is marked L or coloured brown.
Always ensure that the plug cord grip is fastened correctly. If a 13A (BS1363)
fused plug is used it must be fitted with a 13A fuse conforming to BS1362 and
be ASTA approved. If in doubt contact a qualified electrician.
Max. pressure water supply 0.3 Mpa
Water temperature 40ºC
Degree of protection IPX5
Insulation Class
BROWN
(LIVE)
BLUE
CABLE
(NEUTRAL)
GRIP
13