Table of Contents
Advertisement
OPERATING INSTRUCTION
Using the Detergent Dispenser
1. Ensure that the Pressure Washer
is switched off.
2. You can only fix the Spray Lance
J onto the Detergent Dispenser M
(i.e. not the Spray Lance Extension
K ). Push fit then rotate clockwise
until it locks into place.
See fig. 9.
CAUTION :
Ensure that
both parts are firmly
connected together otherwise it
could be hazardous if the nozzle
flew off.
3. Unscrew the detergent container
and fill with the required detergent
(ensure that you follow the
manufacturer's instructions for use).
See fig. 10.
NOTE :
Only use mild
diluted household
detergent, use with any other
chemicals or undiluted detergent
can damage this product and
cause serious injury. No Detergent
will be dispensed in High Pressure
Mode.
4. Switch on the Pressure Washer
and the low pressure water supply
will begin to fill the container and
produce a soapy spray.
5. To rinse the detergent off, re-attach
the nozzle attachment and use the
water spray.
10
before carrying out any
maintenance task
J
Care and Maintenance
We strongly recommend routine
fig. 9
maintenance of the following:
M
1. Nozzle: Visually check to see if
J
M
2. Water Connection: After use,
fig. 10
CARE & MAINTENANCE
WARNING :
Always
disconnect from Mains
the nozzle is free of grit or dirt.
Carefully remove any dirt using the
Nozzle Cleaning Needle O . Then
rinse from the outside with clean
water.
See fig. 11.
NOTE: When cleaning the Nozzle
1. Ensure that the appliance is
switched off and the mains
supply is disconnected.
2. Ensure that the water supply
has also been turned off fully
from the tap.
3. Clean dirt from the nozzle hole
with enclosed needle and
rinse from the front.
carefully remove the Inlet Filter from
the Water Supply Inlet C with flat
nosed pliers and check that there
are no obstructions - if there are
then rinse and clean the filter.
See fig. 12.
fig. 11
O
K
C
Inlet Filter
fig. 12
11
Hide quick links:
Advertisement
Table of Contents
