Operating Instructions - Assembly; Assembling The Lance; Connecting The High Pressure Hose/To The Water Supply - Challenge 1500W High Pressure Washer Instruction Manual

OPERATING INSTRUCTION - ASSEMBLY
Before carrying out any
assembly/disassembly of
the unit please ensure that
the unit is unplugged from the
electrical supply.

Assembling the Lance

1. Screw the Spray Lance J into the
Trigger Gun F .
See fig. 1.
2. Connect the Spray Lance Extension
K to Spray Lance J by pushing
the bayonet on the Lance into the
socket of the Spray Lance J until
it clicks into position. Then rotate
clockwise until it locks in place. This
assembly must be carried out prior
to using the Pressure Washer.
See fig. 2.
CAUTION :
Ensure that
both parts are firmly
connected together otherwise it
could be hazardous if the nozzle
flew off.
3. Always remove or replace parts
whilst the Pressure Washer is
switched off.
K
6
J
fig. 1
J
fig. 2
OPERATING INSTRUCTION - ASSEMBLY
Connecting the High Pressure Hose
1. Screw the fitting on High-Pressure
Hose I onto the High Pressure
Hose Outlet B . Ensure that the
connector is firmly fastened (but do
not over tighten).
See fig. 3.
F
Connecting to the Water Supply
1. Connect the Hose Adaptor P to
the Water Supply Inlet C . Then
connect your garden hose to Hose
Adaptor P . Ensure that the
connector is firmly fastened (but do
not over tighten).
See fig. 4.
NOTE :
The minimum
length of supply hose (not
included) advised is 6 metres with
a diameter of 12.5mm (1/2") to
avoid back pressure and any
associated potential damage to
your Pressure Washer.
B
fig. 3
I
C
P
fig. 4
7