Replacing Seat Upholstery; Replacing Back Upholstery - Invacare Veranda 3000 series User Manual

Invacare ® Veranda™ 3000/4000
1. Insert the back cane A into the wheelchair frame B, aligning
the mounting hole C in the back cane with one of three height
settings D in the wheelchair frame.
When securing the back cane to the wheelchair frame,
ensure the head of the hex screw sets into the desired
hex shaped height setting.
Using the threaded handle E and the hex screw F, secure the
2.
back cane to the wheelchair frame.
3. Repeat STEPS 1 and 2 to install the remaining back cane.
Veranda 4000 Shown in figure.

5.5 Replacing Seat Upholstery

1. Remove the eight phillips screws A and washers B that secure
the existing seat upholstery C to the crossbraces D.
2. Remove the existing seat upholstery from the crossbraces.
3. Install new seat upholstery by reversing STEPS 1-2.
30
A
A

5.6 Replacing Back Upholstery

Wheelchairs with Seat Positioning Strap ONLY: The bottom
mounting screw of each back cane also secures the seat
positioning strap to the wheelchair. If a seat positioning
strap is installed note the position in relation to the back
upholstery before removing the back upholstery. The seat
positioning strap must be reinstalled in original position.
Remove the six mounting screws A and washers B that secure
1.
the existing back upholstery C (and seat positioning strap if
installed) to the back canes D.
2. Remove existing back upholstery from the back canes.
3. Securely tighten the new back upholstery (and seat positioning
strap if installed) to the back canes with the phillips screws and
washers.
1567855-C