Table of Contents
Advertisement
10 (93)
ethernet TCP/IP network. If you connect directly to one of the Master Nodes
using USB, a modem, or a COM port, you will be able to configure that device but
not any other device.
Touch Screen Unit
(Master Node)
Figure 2. TX3 devices connected to an ethernet TCP/IP network. Devices
connected to an ethernet network are Master Nodes.
Notes:
In order for a panel to be a Master Node it must satisfy the following
conditions.
•
It must be IP capable. Panels that are IP capable are usually
denoted by a "-A" at the end of their model names.
•
If the panel is not a Touch Screen, it must have a TX3-IP IP
Module installed.
TX3 Touch Screen Installation Manual
Copyright 2015
Ethernet Network
Card Access Controller
(Master Node)
Elevator Restriction Unit
(Master Node)
Card Reader A
Card Reader B
Introduction
Version 3.4
LT-996
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3-TOUCH-K15-A and is the answer not in the manual?