The dishwasher does not fill/drain
Problem
The buzzer sounds.
The Inlet/Drain check
indicator flashes.
The buzzer sounds.
The dishwasher stops
during a programme.
The Inlet/Drain check
indicator flashes.
Fault code FXX shows
in the display.
Possible cause
The tap is closed.
Fault F12/F13:
Water intake is
restricted.
Fault F11:
Water outlet is
restricted, water
remains in the wash
cabinet at the end of
a programme.
Problem solving guide
Remedy
Open the tap fully.
Before rectifying the problem
you must:
– Switch the dishwasher off with
the On/Off button K.
– Open the tap fully.
– Clean the water inlet filter (see
Maintenance).
– The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
– Clean the filter combination.
See Cleaning and care.
– Clean the drain pump. See
Maintenance.
– Clean the non-return valve.
See Maintenance.
– Remove any kink in the drain
hose.
49