Factory Default Setting - Miele G 1XXX Operating Instructions Manual

Factory default setting

If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^ Switch the dishwasher off with the
On/Off button K.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twelve
times.
The Delay start indicator light will give
one long flash and two brief flashes at
intervals and "p 0" or "p 1" will flash in
the Time display.
Additional functions
The flashing sequence in the Time
display shows whether a setting other
than the factory default setting has
been set.
– "p 1": All settings are set to factory
default settings.
– "p 0": At least one setting has been
changed.
^ To reset the dishwasher to the factory
default settings, press the Start/Stop
button.
^ Switch the dishwasher off with the
On/Off button K.
41