The Dishwasher Does Not Fill/Drain - Miele G 1143 SCi Operating Instructions Manual

Problem solving guide

The dishwasher does not fill/drain

Problem
The Inlet/Drain
check indicator
flashes.
The dishwasher
stops during a
programme.
The Inlet/Drain
check indicator
flashes.
Fault code FXX
shows in the display.
Downloaded from DishWasher-Manual.com Manuals
46
Possible cause
The stopcock is
closed.
Fault F12/F13:
Water inlet restricted.
Fault F11:
Water outlet is
restricted, water
remains in the wash
cabinet at the end of a
programme.
Remedy
Open the stopcock fully.
Before rectifying the problem
you must:
– Switch the dishwasher off with
the On/Off button s.
– Open the stopcock fully.
– Clean the water inlet filter (see
"Problem solving").
– The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
– Clean the filter combination.
See "Cleaning and Care".
– Clean the drain pump. See
"Problem solving".
– Clean the non-return valve.
See "Problem solving".
– Remove any kink in the drain
hose.