Additional Functions; Factory Default Setting - Miele g1022scu Operating Instructions Manual

Additional functions

Factory default setting

If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^ Switch the dishwasher off using the
K button.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the K button.
Keep the Start/Stop button pressed in
until the Start/Stop indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^ Turn the programme selector to the
"11 o'clock" position.
The "Wash/Rinse" indicator light will not
be lit up (indicating that at least one
setting has been altered from the
factory default settings).
^ Press the Start/Stop button.
The "Wash/Rinse" indicator will now
flash briefly at intervals (indicating that
all settings are now the factory default
ones).
^ Turn the programme selector to the
"9 o'clock" position.
The Wash/Rinse indicator light shows
whether a setting other than the factory
default setting has been set.
– If the Wash/Rinse indicator light is
flashing:
All settings are factory default
settings.
– If the Wash/Rinse indicator light is
not lit up:
At least one setting has been altered
from the factory default setting.
^ Press the Start/Stop button if you
wish to re-set all the factory default
settings.
^ Switch the dishwasher off using the
K button.
Operation
37